Project Manager Interview Questions Answers: Part 8

2/05/2011 No Comment

Project Manager Interview Questions,Project Management Interview, Project manager Skills, Customer Relationship Interview Questions

Is spending in IT project’s constant through out the project?
Note:- It’s a tricky question , to know how much depth you have regarding costing of projects.
Normally in initial stage of project’s (requirement and design phase) the cost is very less (As you need maximum is business analyst and architecture), but as the project proceeds cost factor starts increasing.The cost is maximum in coding phase (this is where you require programmers , project leads and project manager).Later when the project is in testing and acceptance phase cost is less as we will need only one or two programmers for removing bugs , than the whole team.

Who is a stakeholder ?
A stakeholder is anyone who has something to gain or lose as a result of the completion or failure of this project or phase
Note:- It’s not only the end customer the stakeholder .Project managers , Project Lead , even programmers , testing department etc.. are stake holders of project.So during project management interview whenever you refer stakeholder’s be clear about the terminology.

Can you explain project life cycle ?
Twist :- How many phases are there in software project ?

There are five stages of any project initiating, planning, executing, controlling, and closeout.These are very general phases and change according to domain.Example when writing a book i will have following mapping’s initiating(contacting publishers,getting

copy right etc.), planning(Table of contents of book ,Number of chapters , tool to use,chapter wise deadlines etc), xecuting(Actually writing the book), controlling(proof reading , language checks , page alignments etc), and closeout(Finally printing and on the
shelf for sale).So this classification is at very broader level , for software development the above figure shows the mapping.

During Software project management interview expected answer is requirement phase, design phase ,coding phase , testing phase and project closure.But you can just impress the answer by giving a general answer and then showing the mapping.

Are risk constant through out the project ?
* Never say that risk is high through out the project.
Risk is high at the start of project’s , but by proper POC (Proof of concept) risk is brought in control.Good project manager’s always have proper risk mitigation plan at the start of project.As the project continues one by one risk is eliminated thus bringing down
the risk.
Related Posts

No comments :


Aired | The content is copyrighted and may not be reproduced on other websites. | Copyright © 2009-2015 | All Rights Reserved 2015

Contact Us | About Us | Privacy Policy and Disclaimer